Kingston 32GB 1333MHz DDR3 Non-ECC

Desktop DDR3 32GB PC3-10660 PC3-10660 1333Mhz DDR3 Non-ECC CL9 DIMM (kit of 4)

ValueRAM's KVR1333D3N9K4/32G is a kit of four 1G x 64-bit (8GB) DDR3-1333 CL9 SDRAM (Synchronous DRAM), 2Rx8, memory modules, based on sixteen 512M x 8-bit FBGA components per module. Total kit capacity is 32GB. The SPD's are programmed to JEDEC standard latency DDR3-1333 timing of 9-9-9 at 1.5V. Each 240-pin DIMM uses gold contact fingers.

• Programmable CAS Latency: 9, 8, 7, 6
• Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%)
• PCB: Height 1.18 inch (30mm), double sided component
• VDDQ = 1.5V (1.425V ~ 1.575V)
• 8 independent internal bank
• Bi-directional Differential Data Strobe
• On Die Termination using ODT pin
• Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS]
• Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
• JEDEC standard 1.5V (1.425V ~ 1.575V) Power Supply
• Asynchronous Reset
• Programmable CAS Write Latency(CWL) = 7 (DDR3-1333)
• 667MHz fCK for 1333Mb/sec/pin
• 8-bit pre-fetch
• Average Refresh Period 7.8us at lower than TCASE 85°C, 3.9us at 85°C < TCASE < 95°